Skip to content
Athens Concrete Pros
Our crew pouring a residential concrete driveway

Walton County · 23 miles from Athens

Concrete contractors in Monroe, GA

Driveways, patios, slabs, walkways and repairs in Monroe. We visit, measure and write up the price for free, then pour on the date we set with you.

Concrete work in Monroe

Monroe is a city of about 14,928 people in Walton County, roughly 23 miles from Athens. Monroe is the Walton County seat, south-west of Athens. Its older streets have houses with aging walks, steps and driveways, and the newer neighborhoods on the edges bring patio, pad and driveway-extension work.

We send the same crews to Monroe that work in Athens, and you get the same estimate: every part of the job listed and priced, and one date for the pour.

What we pour in Monroe

Clay, rock and drainage

The ground in Monroe is Piedmont red clay, the same as in Athens, with rock in places not far under it. Clay is slow to drain and shifts as it takes on water and dries out, so before pricing we walk the site after asking how it behaves in rain: where the gutters discharge, where it stays muddy, which way the old slab has leaned. The job is then built around that. Soft material is removed, crushed stone is placed and compacted, the slab is sloped to move water off and away, and joints are cut where we want any cracking to happen.

Permits in Monroe

Expect a permit for a driveway entrance on a public road, for a wall above a certain height and for any slab that will carry a structure. In Monroe those come from the City of Monroe or Walton County, under rules that differ from the ones in Athens. We name the permits your job needs on the estimate and obtain them ourselves.

Concrete conditions in Monroe

Averages from the nearest NOAA climate normals station, Winder 4S, GA (9 miles away, 889 ft), over 1991–2020.[1] Conditions can change over short distances, so treat these as a planning guide, not a forecast.

Nights at 32°F or below
59
Days at 90°F or above
38
Precipitation a year
51 in
Average temperature
61°F

Heat and drying

Summer brings about 38 days at 90°F or hotter, 32 of them in June–August. High temperatures speed up setting and drying, which raises the risk of plastic shrinkage cracks. For a summer pour we schedule outside the hottest part of the day and protect the slab from drying too fast. NRMCA's hot-weather guidance covers retarders, early starts and curing.[4]

Cold and freeze-thaw

Freezing nights are a regular part of winter in Monroe, about 43 of them in December–February, but rare outside it. A pour between late fall and early spring may need the cold-weather precautions ACI describes for air temperatures expected below 40°F. For driveways, walks and patios that freeze while wet, NRMCA recommends air-entrained concrete to resist scaling. Our estimates say whether the mix is air-entrained.[2, 3]

With 51 inches of precipitation a year, we plan how fresh concrete gets covered if rain arrives during or soon after the pour, and slope the finished slab to shed water away from the house.

  1. NOAA National Centers for Environmental Information, U.S. Climate Normals 1991–2020 (annual and seasonal, by station) (archive c20230404; imported November 6, 2026), station USC00099466.
  2. American Concrete Institute, ACI 306R-16: Guide to Cold Weather Concreting (preview) (2016 edition; checked October 6, 2026).
  3. National Ready Mixed Concrete Association, CIP 2: Scaling Concrete Surfaces (checked October 30, 2026).
  4. National Ready Mixed Concrete Association, CIP 12: Hot Weather Concreting (checked October 30, 2026).

What to have ready for your Monroe estimate

None of it is required to send the request. It just makes the callback shorter and the estimate more accurate.

  • The property address, so we can check the permit office and get the right crew
  • Rough dimensions: pace it out or measure the longest and widest points
  • What it's for: cars, a work truck, a hot tub, a shed, foot traffic
  • A couple of photos of the area and the route a concrete truck would take
  • Anything you've noticed about water: puddles, a downspout, a low corner
  • When you'd like it done

Free concrete estimate in Monroe

Step 1 of 3

What kind of project is it?
About the project
Your contact details

Free, no obligation. We call to schedule, then come out. We never sell your details.

What Monroe homeowners ask

Do you take jobs in Monroe?

+

We do. Monroe is roughly 23 miles from Athens and part of our normal round. You book the estimate visit and the pour the same way as someone in town.

Who handles permits in Monroe?

+

Monroe is in Walton County, so any permit comes from the City of Monroe or Walton County and not from Athens-Clarke County. We find out what your job needs and apply for it.

What should I budget for a concrete driveway in Monroe?

+

We do not publish Monroe prices. As a guide, ConcreteNetwork gives a national range of about $5 to $8 per square foot installed for a plain concrete driveway and $8 to $21 for decorative finishes. Your written estimate, with demolition, base and finish shown separately, is the number to plan on.

How soon could you start in Monroe?

+

We usually visit within a few days of your request. When you accept the estimate we pick the pour date with you and watch the weather as it approaches.

Why Athens homeowners call us

Nothing hidden in the price

The estimate lists thickness, stone base, steel, finish and removal separately. Put another quote beside it and the gaps show.

We ring back the same day

As a rule on the same working day, to go over the job and settle a time for the visit that fits your week.

Insured, permits included

Liability insurance on every crew, with the certificate attached to your estimate. If the job needs a permit, we apply for it.

Request your free estimate

Other towns we cover

Get my free estimate